Results 1 to 4 of 4

Thread: BMW Z8 Club Reinforcement Bracket

  1. #1

    BMW Z8 Club Reinforcement Bracket


    I found this out via the Club, which sent me this free of charge, another benefit of being a Member. My car is in winter hibernation which means its up on a lift and I will drive it once every few weeks but not too often. I plan on installing this in the Spring when the weather is a bit more mild.

    The reinforcement-bracket for the rear bumper (bottom part) of the BMW Z8 is solely developed by the BMW Z8 Club e.V., it is made of brushed stainless steel and manufactured in laser-cut-technology, it is exclusively available from the Club-owned Z-Acht GmbH.

    The often occurring bulging of the bottom part of the rear bumper will be completely prevented with the installation of the reinforcement-bracket. Without the reinforcement-bracket this bulging can lead to massive noise development in the tail area of the vehicle due to air circulation and resonance and eventually leads to tears in the lower part of the rear bumper next to the screws.

    Full info from the Club is also posted here -

  2. #2
    Z8 Millennial Monster hayvenhurstkid's Avatar
    Join Date
    Jul 2007
    I had my independent mechanic install mine today. Took less than ten minutes. He said the part is of very high quality and he can see why it is important to install one on the car.

    2001 Z8
    2014 Range Rover sport Autobiography
    2013 Ford Raptor
    2011 Porsche 911 turbo S coupe

  3. #3
    Thanks Marty- thats great info. Things like this make the Club membership such a good value.

  4. #4
    Absolutely, second that for sure!!
    Andrew Macpherson

    Expert Z8 Inspections, with full support for both Z8 sale and purchases.